Qfx5200 Installation Safety Guidelines; Unpacking And Mounting The Qfx5200 - Juniper QFX5200 Hardware Manual

QFX5200 Installation Safety Guidelines

The weight of a fully -loaded QFX5200-32C and QFX5200-32C-L switch chassis is approximately 23.5
lb (10.66 kg); and a QFX5200-48Y weighs between 20.78 lbs (9.43 kg) to 21.16 (9.6 kg) with power
supplies and fans installed. Observe the following guidelines for lifting and moving a QFX5200:
CAUTION: If you are installing the QFX5200 above 60 in. (152.4 cm) from the floor,
either remove the power supplies, fan modules, and any expansion modules before
attempting to install the switch, or ask someone to assist you during the installation.
• Before installing a QFX5200, read the guidelines in
to verify that the intended site meets the specified power, environmental, and clearance
requirements.
• Before lifting or moving the QFX5200, disconnect all external cables.
• As when lifting any heavy object, lift most of the weight with your legs rather than your back. Keep
your knees bent and your back relatively straight and avoid twisting your body as you lift. Balance
the load evenly and be sure that your footing is solid.
RELATED DOCUMENTATION
QFX5200 Site Guidelines and Requirements | 65
Installation Instructions Warning | 174
General Safety Guidelines and Warnings | 169

Unpacking and Mounting the QFX5200

IN THIS SECTION
Unpacking a QFX5200 | 97
Register Products—Mandatory to Validate SLAs | 99
Mounting a QFX5200 in a Rack or Cabinet | 99
"QFX5200 Site Preparation Checklist" on page 57
96