Table of Contents
Advertisement
Chapter 5
Getting Connected
Mounting Peripheral Devices
If you plan to use any peripheral devices with your GC, such as an autosampler or
data system, you will need to unpack them and follow any setup instructions
included with them. Follow the instructions in the sections below to connect your
peripheral devices to the GC.
Connect the Data System Computer
There are two types of information transfer techniques between the FOCUS GC
and the computer: digital and analog. Use the following procedure to connect your
data system computer to the GC for digital transfer:
1. Connect the computer, monitor, keyboard, mouse, printer (if applicable), and
2. Plug in the computer, monitor, and printer power cables.
3. Connect the RS232 cable supplied with the data system to one of the COM
4. Connect the other end of the cable to the port on the rear of the GC labeled
5. Turn on the GC (if it is not already on), the computer, the monitor, and the
6. Test the printer and network connections and install drivers as necessary.
Refer to your data system's operating manual for instructions on configuring your
data system and using it to control GC functions and process information from
the GC.
66
network connection (if applicable) according to the instructions in the
accompanying documentation.
ports of you computer, taking note of which port you use. You will need this
information for software configuration.
COMPUTER.
printer. Check the time, date, and monitor settings.
Mounting Peripheral Devices
Site Preparation and Installation Manual
Advertisement
Table of Contents
