Table of Contents
Advertisement
Chapter 1
Laboratory Preparation
•
•
Supplemental Equipment
The following items are supplemental equipment necessary for the installation of
your FOCUS GC system. Some of them are supplied with the instrument.
•
•
•
•
•
•
•
•
•
•
•
NOTE
It is the responsibility of the customer to replace any consumables used during installation.
38
gas flow meter (Thermo Scientific GFM Pro Flowmeter, or equivalent)
Allen wrench set including 1.5 mm, 2 mm, 2.5 mm, 3 mm, 4 mm, 5 mm, and
6 mm wrenches
carrier gas (refer to
Gas and Plumbing Requirements
information about the carrier gas requirements for your gas chromatograph)
detector gas (refer to
detector gas requirements for your gas chromatograph)
dual-stage gas cylinder pressure regulators with an output pressure range of
0–700 kPa (0–100 psi), stainless steel diaphragms, and a 1/8-in. Swagelok
terminate nut
sample syringe (5 or 10 l)
columns (a 7 m test column is supplied with each GC)
tubing and fittings for carrier and detector gases (refer to
page 35 for the tubing and fitting requirements for your gas chromatograph)
spare septa
column ferrules
®
Swagelok
fittings
leak detector (Thermo Scientific GLD Pro, or equivalent, or 50/50 IPA/water
solution)
data system or integrator (refer to
Requirements
on page 39 for the data system requirements)
Gas and Plumbing Requirements
Hardware and Software Minimum
Supplemental Equipment
on page 32 for
on page 32 for the
Gas Tanks
Site Preparation and Installation Manual
on
Advertisement
Table of Contents
