Plumbing The Gas Supply To The Gc - Thermo Scientific FOCUS GC Site Preparation And Installation Manual

Plumbing the Gas
Supply to the GC
This chapter explains the proper gas supply connections and configuration
information for your GC. Use the information in this chapter to connect your inlet
and detector gas supplies.
Chapter at a Glance...
Using
Connecting the Gas
Adding Traps to the Gas
Purging Gas Lines
Connecting the Gas Supply to the
Connecting the Servo Air for the Gas Sampling
Testing for Leaks
Before you begin plumbing gas to the GC, locate the main power cable and
position it near the appropriate outlet. Do not plug in the power cable at this
time. Follow the procedures in this section to build your gas supply lines for
carrier, make-up, and detector gases.
CAUTION DO NOT loosen or remove caps from the GC until you have purged your gas lines
and are ready to connect them. Loosening or removing caps early will contaminate
instruments and filters.
Site Preparation and Installation Manual
Hydrogen....................................................................................................54
Supplies................................................................................56
Supply...........................................................................57
................................................................................................58
..................................................................................................64
GC..................................................................59
Valve........................................63
4
53