Bench Mounting; Wall Mounting (Optional) - Thermo Scientific EASYpure 1164 Series Operation Manual And Parts List

Caution
Do not unscrew the cover, as this will
loosen the water tight seal and thus
damage the UV lamp.
Caution
Do not touch the glass portion of the
UV lamp. We recommend that you
wear lint-free gloves when handling the
lamp. The glass portion must be free of
fingerprints, perspiration, etc. Even a
single fingerprint will reduce the effec-
tiveness of the lamp. If you accidentally
touch the glass portion of the lamp,
clean the lamp with a lint-free cloth;
use isopropyl alcohol if required.
Note
The UV lamp and receptacle fit togeth-
er one way. If they do not readily
match holes to prongs, rotate the lamp
90° and try again.
Warning
Do not locate the EASYpure UV/UF
directly over the equipment that
requires electrical service. Routine
maintenance of this unit may involve
water spillage and subsequent electri-
cal shock hazard if improperly located.
Do not use in the presence of flamma-
ble or combustible materials; fire or ex-
plosion may result. The device
contains components which may ignite
such materials.
the cover with the screws removed in step 1.
Close the cartridge access door. Replace the
pump interlock plug. If you are bench mount-
ing the unit, go to Bench Mounting. If you are
wall mounting the EASYpure UV/UF, go to
Wall Mounting .

Bench Mounting

1. Place the EASYpure UV/UF on a bench top
that is accessible to water, electricity and an
atmospherically vented drain, and that is con-
venient to your work area, noting the
Clearance Requirements.

Wall Mounting (Optional)

Install the optional wall bracket on the wall in a location
that is accessible to water, electricity and an atmospheri-
cally vented drain, and that is convenient to use. A mini-
mum of 4 fasteners must be used.
1. Remove the four feet from the EASYpure
UV/UF and retain the screws.
2. Place the EASYpure UV/UF on the wall
bracket swivel base so the screw holes where
the feet were attached line up with the holes
in the wall bracket. There are guides on the
wall bracket that will mate with the EASYpure
UV/UF. See Figure 7.
3. Reinstall the four screws removed in step 1
through the bottom of the wall bracket and
into the EASYpure UV/UF.
I
NSTALLATION
11