Lan Interface - ITech IT-M3100D Series User Manual

2.7.2 LAN Interface

When the user's optional interface card is a LAN+USB interface (IT-E1206), the
following is required to use the LAN interface.
LAN Connection
Use the following steps to quickly connect your instrument to your LAN and con-
figure it. Two typical LAN interface systems are described below: private LAN
and site LAN.
•
•
b. Use left and right keys or rotate the knob to select Comm and press
[Enter] key to confirm.
c. Use left and right keys or rotate the knob to select USB and press
[Enter] key to confirm.
d. Rotate the knob to select the desired interface type and press [Enter]
key to confirm.
•
TMC: USB_TMC interface;
•
VCP: virtual serial port. Select this type, you need to install the corre-
sponding driver (download from the ITECH website or contact ITECH
agent) for win7 OS. The device manager of PC will display 'Prolific
USB-to-Serial COM Port' after installing. No need to install VCP driver
for win10 and above systems.
e. After finishing the setting, press [Esc] to exit.
Connect to the private LAN
A private LAN is a network in which LAN-enabled instruments and com-
puters are directly connected. They are typically small, with no centrally
managed resources. When connected to a computer, a direct attached net-
work cable can be used to connect directly to the computer via the LAN
interface.
Connect to the site LAN
A site LAN is a local area network in which LAN-enabled instruments and
computers are connected to the network through routers, hubs, and/or
switches. They are typically large, centrally-managed networks with services
such as DHCP and DNS servers. When connected to a computer, a direct
attached network cable can be used to connect to the router, and the com-
puter is also connected to the router.
Copyright © Itech Electronic Co., Ltd.
Inspection and Installation
27