Fuse Connections; Sensor Connections; Db26 Sensor / Serial Cable Connection (Cab000356) - Gatekeeper Y724 User's Operating Manual

Hide thumbs Also See for Y724:

Table of Contents

Y724 User Operating Manual

GROUND

Connect to the negative terminal of the battery, -12V. Typically, grounds are

(GND)

established in the fuse panel, and installers would need to be connected there.

IGNITION

Connect to the vehicle ignition, +12V, signal required to activate the device.

Ensure that the provided 3 AMP fuse is used. Ignition can be obtained from

(IGN)

the ignition solenoid post.

POSITIVE

Connect to the positive terminal of the battery, +12v. Ensure that the

(VCC)

provided 15 AMP inline fuse is used. +12V can be obtained from the battery

solenoid post, or the cables that connect directly to the battery from the fuse

panel.

10.3.2 - Fuse Connections

The sensor cable CAB000356 connects to the DB26 connector marked "SERIAL" on the

back of the device. The sensor portion of the cable is 5 metres sheathed together. Wires

are colour coded and labelled with its corresponding Sensor number.

The 2-pin Molex connector can be used to connect a Zoom Camera (optional) to the

recorder.

FUSES

141 of 149

Table of Contents