Gatekeeper Y724 User's Operating Manual page 128

Y724 User Operating Manual
video display, recording and snapshot
options associated with this alarm.
The Linkage setup screen enables you to
configure the following options:
Channel – checkboxes which allow
§
you to select any combination of the
camera channels to be included in
the display and recording.
Post Recording – drop list which
§
allows you to select the duration for
which video will continue to be
recorded when the alarm is
triggered.
Lock – checkbox, if selected will
§
mark the recorded video associated
with this alarm as locked video.
Linkage IO Output – checkboxes, if
§
enabled, the device will send a signal
to the selected IO output lines.
Output Delay Time – numeric field
§
to set the delay time for the IO
output (in seconds).
Linkage Screen – drop list to select
§
the options to display the video from
the selected cameras on-screen
when the alarm occurs.
None : Not displayed.
-
Single : Display 1 camera.
-
- Double : Displays 2cameras
Quad : Displays 4 cameras.
-
If Single (1x1), Double (1x2), or Quad (2x2)
display is selected, the (Setup) button allows
you to select the layout of the channels to be
displayed on-screen.
The drop lists are shown on-screen
according to the grid layout mode selected.
You can easily choose each individual
camera channel to be displayed in the
selected grid segment visually. If you have
less cameras than available grid segments,
128 of 149