Gatekeeper Y724 User's Operating Manual page 124

Y724 User Operating Manual
Linkage
which to monitor for video loss events.
These settings would need to be determined
by the customer/client to match their
specific business requirements.
Click the (Setup) button under Linkage to
go to the Linkage setup screen. This sets up
the video display, recording and snapshot
options associated with this alarm.
The Linkage setup screen enables you to
configure the following options:
Channel – checkboxes which allow
§
you to select any combination of
the camera channels to be included
in the display and recording.
Post Recording – drop list which
§
allows you to select the duration for
which video will continue to be
recorded when the alarm is
triggered.
Lock – checkbox, if selected will
§
mark the recorded video associated
with this alarm as locked video.
Linkage IO Output – checkboxes, if
§
enabled, the device will send a
signal to the selected IO output
lines.
Output Delay Time – numeric field
§
to set the delay time for the IO
output (in seconds).
Linkage Screen – drop list to select
§
the options to display the video
from the selected cameras on-screen
when the alarm occurs.
None : Not displayed.
-
Single : Display 1 camera.
-
- Double : Displays 2cameras
Quad : Displays 4 cameras.
-
If Single (1x1), Double (1x2), or Quad (2x2)
display is selected, the (Setup) button allows
you to select the layout of the channels to
be displayed on-screen.
124 of 149