Table of Contents
Advertisement
Industrial Electronic Devices
SET COMMUNICATION:
This section define the fundamental communication parameters of two buses, KNX and PROFINET.
By Pressing the
"Set
Communication" button from the main window for SW67818 (Fig. 2) the
window "Set Communication" appears (Fig. 3).
The window is divided in two sections, one for the KNX and one for the PROFINET.
The means of the fields for "KNX" are:
In the field "Type" the type of KNX is defined (fixd to 'KNX TP');
In the field
"ID
Device" the ID of the KNX side of the converter is defined.
The means of the fields for the "PROFINET" section are:
In the fields
"IP
ADDRESS" the IP address that you want to give to the Converter is defined;
In the fields
"SUBNET
Mask" the SubNet Mask is defined;
In the fields "GATEWAY" the default gateway that you want to use is defined. This feature
can be enabled or disabled pressing the Check Box field. This feature is used for going out of
the net;
In the field "Port" is possible to define the port to use for the PROFINET communication (fixed
to 34964);
In the field
"PROFINET Name of
node;
In the fields
"Number Byte
In the fields
"Number Byte
ADFweb.com Srl – IT31010 – Mareno – Treviso
Station" is possible to assign a name to the PROFINET
IN" insert the number of input byte of the slave station;
Out" insert the number of output byte of the slave station.
User Manual PROFINET / KNX
Document code: MN67818_ENG
Figure 3: "Set Communication" window
INFO:
www.adfweb.com
Phone +39.0438.30.91.31
Revision 1.000
Pagina 15 di 23
Advertisement
Table of Contents
