Table of Contents
Advertisement
Industrial Electronic Devices
SET COMMUNICATION:
This section define the fundamental communication parameters of two buses, IO-Link and
Modbus.
By Pressing the
"Set
Communication" button from the main window for SW67961 (Fig. 2)
the window "Set Communication" appears (Fig. 3).
The means of the fields for "Ethernet Connection" are:
In the field
"Device Name
defined;
If the field
"Obtain an IP Address Automatically (DHCP for Cable
is checked, DHCP for LAN connection is enabled;
If the field
"Enable
DNS" is checked, DNS protocol is enabled;
In the field
"Primary
DNS" the IP Address of the primary DNS server is defined;
In the field
"Secondary
The means of the fields for "IO-Link Slave" are:
In the field "Baudrate" the standard baudrate used by the IO-Link interface is
defined.
The means of the fields for the "Modbus Master" section are:
In the field "Serial" the serial to use is defined (RS232 or RS485);
In the field "Baudrate" the baudrate for the serial line is defined;
In the field "Parity" the parity of the serial line is defined;
In the field
"Stop
Bits" the number of Stop Bits of the serial line is defined;
In the field
"TimeOut
(ms)" the maximum time that the converter attends for the
answer from the slave interrogated is defined;
In the field
"Cyclic Delay
is defined.
ADFweb.com S.r.l.
(Hostname)" the Hostname to assign to the converter is
DNS" the IP Address of the secondary DNS server is defined.
(ms)" the delay (idle time) between two Modbus requests
User Manual IO-Link Slave / Modbus Master
Document code: MN67961_ENG
Connection)"
Figure 3: "Set Communication" window
Revision 1.000
Page 20 of 33
Advertisement
Table of Contents
