Table of Contents
Advertisement
Industrial Electronic Devices
SET COMMUNICATION:
This section define the fundamental communication parameters of two buses, IO-Link and
CANopen.
By Pressing the
"Set
Communication" button from the main window for SW67968 (Fig. 2)
the window "Set Communication" appears (Fig. 3).
The means of the fields for "Ethernet Connection" are:
In the field
"Device Name
is defined;
If
the
field
"Obtain
Connection)" is checked, DHCP for LAN connection is enabled;
If the field
"Enable
DNS" is checked, DNS protocol is enabled;
In the field
"Primary
DNS" the IP Address of the primary DNS server is defined;
In the field
"Secondary
defined.
The means of the fields for "IO-Link Slave" are:
In the field "Baudrate" the standard baudrate used by the IO-Link interface is
defined.
The means of the fields for "CANopen" are:
In the field
"ID
Device" the ID for CANopen side is defined;
In the field "Baudrate" the data rate for CANopen is defined;
In the field
"Set Operational State at
defined. I.e. if it is checked the board starts in Operational State, else it starts in
Preoperational;
In the field
"Network Start at
defined. I.e. if it is checked the board sends a command to set the Operational
State of all the devices present in the network;
In the field
"Delay
(s)" the delay before sending the "Start" command for the
CANopen is defined;
ADFweb.com S.r.l.
(Hostname)" the Hostname to assign to the converter
an
IP
Address
Automatically
DNS" the IP Address of the secondary DNS server is
Start-up" the state of the CANopen is
Start-up" the state of the network CANopen is
User Manual IO-Link Slave / CANopen
Document code: MN67968_ENG
(DHCP
for
Cable
Figure 3: "Set Communication" window
Revision 1.000
Page 18 of 33
Advertisement
Table of Contents
