Table of Contents
Advertisement
Industrial Electronic Devices
SET COMMUNICATION:
This section define the fundamental
EtherNet/IP and Modbus slave.
By Pressing the
"Set
Communication" button from the main window for SW67669 (Fig.
2) the window "Set Communication" appears (Fig. 3).
This section is used to define the main parameters of Modbus line. The means of the
fields are:
In the field "Serial" the serial lien to use for Modbus communication is defined;
In the field "Baudrate" the baudrate for the serial line is defined;
In the field "Parity" the parity of the serial line is defined;
In the field
"Stop
Bits" the number of Stop Bits is defined;
In the field
"ID
Device" the address of serial Modbus device is defined. This field
can be compiled only if the selected "Operation Mode" is "Normal Mode (with
Translate Table)" or "Work with Fix IP Address";
If the field
"Read with Input Register / Status
possible to read the Input bytes of EtherNet/IP side with Input Registers (Function
04) and write the Output bytes of EtherNet/IP side with Holding Registers
(Function 06/16). The Output bytes are readable with Function 03. Otherwise,
only Holding Registers will be used and the Output bytes of EtherNet/IP side
cannot be read back.
The means of the fields for "EtherNet/IP Master" are:
In the fields
"IP
ADDRESS" the IP address for EtherNet/IP side of the converter
is defined;
In the fields
"SUBNET
converter is defined;
In the fields "GATEWAY" the default gateway of the net is defined. This feature
can be enabled or disabled pressing the Check Box field. This feature is used for
going out of the net;
In the field "Port" the port used for EtherNet/IP communication is defined. The
port has a fixed value of 44818.
ADFweb.com S.r.l.
communication parameters of two buses,
Function" is checked, it is
Mask" the SubNet Mask for EtherNet/IP side of the
User Manual EtherNet/IP Master/ Modbus slave
Document code: MN67669_ENG
Figure 3: "Set Communication" window
Revision 1.000
Page 17 of 27
Advertisement
Table of Contents
