Set Communication - ADF Web AXIS HD67594-A1 User Manual

Industrial Electronic Devices

SET COMMUNICATION:

This section defines the fundamental communication parameter of two buses, PROFIBUS and Ethernet/IP.
By pressing the "Set Communication" button from the main window for SW67594 (Fig. 2) the window
"Set Communication" appears (Fig. 3).
The window is divided in two sections, one for the PROFIBUS and the other for the Ethernet/IP.
The means of the fields for "Ethernet/IP" are:
In the fields "IP Address" insert the IP address that you want to give to the Converter;
In the fields "SubNet Mask" insert the SubNet Mask;
In the fields "Gateway" insert the default gateway that you want to use. This feature can be
enabled of disabled pressing the Check Box field;
In the field "Port" insert the number of port;
In the field "Number Byte
defined (at maximum it is possible to use 244 byte);
In the field "Number Byte
defined (at maximum it is possible to use 244 byte).
The means of the fields for "PROFIBUS" are:
In the field "ID Dev." the address of the PROFIBUS side is defined;
In the field "Baud rate" the baud rate for the PROFIBUS side is defined;
ADFweb.com Srl – IT31010 – Mareno – Treviso
Input" the number of byte from the Ethernet/IP to the Converter is
Output" the number of byte from the Converter to the Ethernet/IP is
User Manual EtherNet/IP / PROFIBUS Slave
Document code: MN67594_ENG Revision 1.002
Figure 3: "Set Communication" window
INFO: www.adfweb.com
Page 12 of 22
Phone +39.0438.30.91.31