Lbt Scan Enable; Field Separator; Id Report; No Tag Report - Intermec IF30 User Manual

Chapter 3 — Creating and Using RFID Applications

LBT Scan Enable

(Supported only by 865 MHz readers) Enables ETSI 302-208
channel scanning when the Listen Before Talk algorithm is
enabled.
When this check box is checked, the LBT algorithm looks for a
free transmit channel among the 10 available ETSI 302-208
channels. When this check box is not checked, the transmit
channel is set by LBT Channel.
This setting is equivalent to the LBTSCANENABLE BRI
attribute.

Field Separator

Sets the space character to be used for separating fields in tag
data. Choose either space ( ) or comma (,). Default is space.
This setting is equivalent to the FIELDSEP BRI attribute.

ID Report

Enables or disables tag ID reporting after a Read, Write, or Lock
command is executed:
• For ISO tags, the tag identifier corresponds to TAGID.
• For EPC tags, the tag identifier corresponds to EPCID.
Check the check box to enable tag ID reporting.
This setting is equivalent to the IDREPORT BRI attribute.

No Tag Report

Enables or disables a NOTAG message, which is sent when no
tags are found during execution of a Read, Write, or Lock
command. Check the check box to enable the message.
This setting is equivalent to the NOTAGRPT BRI attribute, and
is enabled by default.

Timeout Configuration Mode

Enables a timeout mode. Instead of specifying the number of
antenna or ID tries, you specify a timeout value. If the IF30 does
not find any tags after an antenna or ID try, the reader waits for
the specified time before starting the next antenna or ID try.
This setting is equivalent to the TIMEOUTMODE BRI
attribute, and is disabled by default.
IF30 Fixed Reader User's Manual 45