VETRON 5000 Service Manual page 97

DISPLAY
» KNIFE POSITION AND PRESSURE
01
02
2 4 T h ea r d c a ch t r
03
h e i g h t a djust
04
05
06
07
08
09
10
NOTICE:
The thread catcher should move easily below the knife without hooking in.
10. KNIFE POSITION TO THREAD CATCHER AND KNIFE PRESSURE
NOTICE:
The thread catcher should not perform any downwards movement during inbound movement
of the knife.
STEP
Activate the ADJUSTMENT WIZARD
(02.01. / Page 19).
» Until chapter 24 appears on the display.
» Confirm.
1
Loosen screws and screw
3
Turn the excentric until the knife is slightly lying on the thread catcher
position (image 2).
1 2
Tighten screws and .
7
Loosen the nut and turn the magnetic core
5
to the thread catcher in outbound position (image 5).
7
Tighten nut .
Perform cutting test at left and right position and check parallelity.
» Confirm to proceed to the next point.
04. SHORT THREAD CUTTER
DESCRIPTION
INFO: Stitch length is set to
0mm, pedal is blocked, the display
shows the machine position in degrees
2
.
8
until the knife has a distance of 0.5 - 0.8mm
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
-2-2
5
while in inbound
05/2019
95