VETRON 5000 Service Manual page 89

1
DISPLAY
» THREAD CUTTING TIMING (CONTROL CAM)
01
02
2 4 T h ea r d c a ch t r
03
h e i g h t a djust
04
05
06
07
08
NOTE:
At top dead center of the take up lever
position. At position 333° the roller of the lever
1
3
5
3
4
STEP
Activate the ADJUSTMENT WIZARD
(02.01. / Page 19).
Until chapter 24 appears on the display.
»
» Confirm.
Loosen screws 4 .
Turn machine with the mechanical handwheel to the position 333°.
5
Move the roller lever into the cam
image 4.
4
Tighten screws while making sure the cam is positioned against the stop on the left side.
» Confirm to proceed to the next point.
04. SHORT THREAD CUTTER
03. THREAD CUTTING TIMING (CONTROL CAM)
1
the thread catcher
5 should be positioned as shown in image 4.
3
DESCRIPTION
INFO: Stitch length is set to 0mm,
pedal is blocked, the display shows the
machine position in degrees.
3
while turning the cam to reach the position shown in
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
2
should be in its parking
2
05/2019
2
4
87