VETRON 5000 Service Manual page 54

03. ADJUSTMENT
16. ADJUSTMENT OF THE FEED DOG HEIGHT
NOTE:
At stitch length 0 the feed dog should be in its highest position, 0.8mm above the stitch plate.
1
DISPLAY
» ADJUSTMENT OF THE FEED DOG HEIGHT
01
02
1 6 F e d e d o g
03
h e i g h t s etup
04
05
06
07
08
09
05/2019
52
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
2
STEP
Activate the ADJUSTMENT WIZARD
(see 02.01. / Page 19).
» Until chapter 16 appears on the display.
» Confirm.
Turn the feed dog in its top dead center (190°) with the mechanical handwheel.
Loosen screw until the feed dog carrier
1
Put the gauge on the stitch plate.
3
Press the feed dog carrier
touching the gauge .
3
Tighten screw .
1
» Confirm to proceed to the next step.
DESCRIPTION
INFO: The pedal is blocked. While
turning by hand the display shows the
machine position in degrees. Stitch
length is set to 0mm.
can be easily moved up and down.
2
with the feed dog upwards until the surface of the feed dog is
2
3 2