VETRON 5000 Service Manual page 60

03. ADJUSTMENT
22. RESTING POSITION OF THE ROLLER LEVER
NOTE:
In the resting position of the roller lever the roller should have a lateral distance of 0.1 to
0.3mm to the control cam.
DISPLAY
» RESTING POSITION OF THE ROLLER LEVER
NOTICE:
The resting position is factory set and should only be adjusted if necessary.
01
02
2 2 R o le l r l e er v
03
p o s s e t p u
INFO:
It is very important that the control cam
04
05
06
07
08
05/2019
58
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
STEP
Activate the ADJUSTMENT WIZARD
(see 02.01. / Page 19).
» Until chapter 22 appears on the display.
» Confirm.
is touching the bushing
5
Turn the machine with the mechanical hand wheel into the shown position of
the control cam .
5
2
Loosen nut and adjust the desired distance between roller lever
0.1 to 0.3 mm with the screw
While turning the machine with the mechanical handwheel, the
roller lever should not jam with the control cam
4
Tighten nut .
2
» Confirm to proceed to the next step.
DESCRIPTION
INFO: The pedal is blocked. While
turning by hand the display shows the
machine position in degrees. Stitch
length is set to 0mm.
.
6
to position .
1 A
.
5
1
2
3
4
A
5
6
and control cam of
4 5