VETRON 5000 Service Manual page 101

DISPLAY
» THREAD CUTTING TENSION ADJUSTMENT
NOTICE:
Additional it is possible to set the thread cutting tension in the parameters (M153) individal according to the
program.
01
02
2 4 T h ea r d c a ch t r
03
h e i g h t a djust
04
05
06
NOTE:
After thread cutting the needle thread should be approximately 35mm long.
1
STEP
Activate the ADJUSTMENT WIZARD
(02.01. / Page 19).
Until chapter 24 appears on the display.
»
» Confirm.
3
Loosen screw and adjust the pretension.
3
Tighten screw and perform a cutting test. If necessary readjust.
» Confirm to proceed to the next point.
04. SHORT THREAD CUTTER
14. THREAD CUTTING TENSION ADJUSTMENT
DESCRIPTION
INFO: Stitch length is set to 0mm,
pedal is blocked, the display shows the
machine position in degrees.
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
05/2019
99