VETRON 5000 Service Manual page 64

03. ADJUSTMENT
25. LATERALLY ADJUSTMENT OF THE THREAD CATCHER
NOTE:
When in position A the thread catcher
plate 2 but not touching.
2
B
A
1
3
DISPLAY
» LATERALLY ADJUSTMENT OF THE THREAD CATCHER
01
02
2 5 T h ea r d c a ch t
03
p o s s e t p u
04
05
06
07
08
05/2019
62
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
1 should be congruent with edge
STEP
Activate the ADJUSTMENT WIZARD
(see 02.01. / Page 19).
» Until chapter 25 appears on the display.
r
» Confirm.
Turn the machine with the mechanical hand wheel until the needle point is positioned below
the stitchplate coming from bottom dead position.
Loosen screw and move the thread catcher
3
Tighten screw .
3
Move the thread catcher by hand to make sure that it is not touching the stitch plate
in any position.
» Confirm to proceed to the next step.
B of the stitch
DESCRIPTION
INFO: The pedal is blocked. While
turning by hand the display shows the
machine position in degrees. Stitch
length is set to 0mm.
according the general rule.
1