VETRON 5000 Service Manual page 94

04. SHORT THREAD CUTTER
08. LATERAL POSITION OF KNIFE BASE TO SEWING DIRECTION
NOTE:
The knife base should have a distance of 16.7mm to the zinc frame.
DISPLAY
» LATERAL POSITION OF KNIFE BASE TO SEWING DIRECTION
NOTICE:
Be careful to keep the knife base parallel to the zinc frame.
01
02
2 4 T h ea r d c a ch t
03
h e i g h t a djust
04
05
06
07
05/2019
92
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
1
STEP
Activate the ADJUSTMENT WIZARD
(02.01. / Page 19).
» Until chapter 24 appears on the display.
r
» Confirm.
1
Loosen screws
Move the knife base
1
Tighten screws
» Confirm to proceed to the next point.
16,7mm
2
16,7mm
.
2
laterally until a parallel distance of 16.7mm is reached.
.
DESCRIPTION
INFO: Stitch length is set to 0mm,
pedal is blocked, the display shows the
machine position in degrees