VETRON 5000 Service Manual page 38

03. ADJUSTMENT
02. ADJUSTMENT OF THE MATERIAL THICKNESS MEASUREMENT SYSTEM
NOTE:
The sensor must have the same distance to the magnetic strip in every position
of the feet.
INFO:
The green and the red LED should be lit in every position.
3
4
DISPLAY
» ADJUSTMENT OF THE MATERIAL THICKNESS MEASUREMENT SYSTEM
INFO:
During adjustment, please check if the magnet strip support
01
02
0 2 M a me t a s u r e
03
s y s t e m s etup
04
05
06
07
05/2019
36
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
STEP
Activate the ADJUSTMENT WIZARD
(see 02.01. / Page 19).
» Until chapter 02 appears on the display.
» Confirm.
In the blocked mode the sewing feet can be moved
up and down by hand while checking if the LEDs
and are lit in every position.
A B
Loosen the screws and move the support
1
into a position in which the LEDs
lit in every sewing feet position.
Tighten screw .
1
» Confirm to proceed to the next step.
DESCRIPTION
is parallel to the presser foot bar
3
INFO: The pedal is blocked.
The sewing feet can be moved
by hand up and down.
2
and are
A B
2
A
B
1
.
4