VETRON 5000 Service Manual page 41

DISPLAY
» ADJUSTMENT OF THE FEEDING DEVICE
01
02
0 4 F e d e d r i v e
03
s e t u p
INFO:
To adjust the feed driving eccentric turn the machine to 9°. In this position screw
Turn the eccentric until the feed dog stopps its movement and fix the screw. Then check your adjustment and assure in
04
position 180° that the feed dog is not moving. The machine switches the feed regulator to permanently move between
forward and reverse position by turning the JOG KEY clockwise. Turn the JOG KEY counterclockwise to stop the move-
ment.
05
N e ed l po e s : 18 0
S e t t i n g pos: 18 0
06
07
NOTE:
When the machine is in the bottom dead center of the needle bar (180°) the feed dog should
not move while switching the feed regulator.
PREADJUSTMENT OF THE FEEDING DEVICE:
If the needle bar is in its top dead center position, the first screw
feed driving eccentric 1 should be facing down.
» Loosen the screws and turn the feed eccentric
2
» In this position slightly tighten both screws
shaft.
STEP
Activate the ADJUSTMENT WIZARD
(see 02.01. / Page 19).
» Until chapter 04 appears on the display.
» Confirm.
Turn the machine to the bottom dead center (180°) with the mechanical handwheel.
Turn the eccentric until the feed dog stops moving, and tighten the screws
1
» Confirm to proceed to the next step.
03. ADJUSTMENT
04. ADJUSTMENT OF THE FEEDING DEVICE
2
in running direction of the
until the first screw is facing down.
1
until the eccentric can be easily turned on the
2
DESCRIPTION
2
can easily be reached.
VETRON 5000 - FLAT BED MACHINE - SERVICE MANUAL
1
2
.
2
05/2019
39