Table of Contents
Advertisement
5.7.2 Fault table
FAULT
System has no Internet
Browser notification: "Page can
not be opened"
Tablet screen remains dark
Not all sensors are displayed in
system information
Sensor is not being charged
743A250 Bionic Pro
PROBABLE CAUSE
Network cable not connected to
router
Identified by:
Right LED on base station not
illuminated
Company network has no Inter
net
Identified by:
Icon on router screen
No WLAN connection
Identified by:
No WLAN icon can be seen in
menu bar
Router is off
Identified by:
LEDs on sensors flashing rapidly
Centre LED on base station
flashing rapidly
iPad connected to wrong WLAN
Identified by:
Tablet is not connected to Bionic
Pro router in WLAN settings
Base station switched off
Identified by:
LEDs on base station not lit
Base station in configuration
mode (button on back accident
ally pressed)
Identified by:
Centre LED (WLAN) on base
station flashing slowly
Battery discharged
Identified by:
Tablet cannot be switched on
Sensor switched off
Identified by:
Sensor not illuminated
Sensor battery drained
Identified by:
Sensor not illuminated
WLAN connection to sensor lost
Identified by:
Sensor no longer illuminated
blue
Sensor defective
Identified by:
Sensor not illuminated despite
previous steps
USB port dirty
Identified by:
Dirt in USB port
USB port defective
SUGGESTED REMEDY
Plug network cable into WAN
socket on the router
Check company network
Contact administrator
Provide
LAN
socket
proxy settings
Connect iPad to WLAN
Switch on WLAN on iPad
Connect router to mains network
Connect iPad to the WLAN of
the Bionic Pro router
Connect base station to mains
network
Unplug base station from mains
network for at least 3 seconds
and then plug back in again
Charge tablet
Switch sensor on
Charge sensor
Move sensor into range of router
Switch sensor off and on again
Contact service
Carefully clean USB port with
compressed air (at 20 cm dis
tance) or a vacuum cleaner
Contact service
Use
without
41
Advertisement
Table of Contents
