Connecting The Router To The Power Supply - Otto Bock 743A250 Bionic Pro Instructions For Use Manual

Preparing product for use

4.2 Connecting the router to the power supply

7
► NOTICE!To maintain functionality, only use the router that came with the product and do not make any modific­
ations to the router settings.
The router is switched on when it is connected to the power supply. The router then sets up the WLAN network
that was configured at the factory (time: approx. 10 min).
► Use the plug (type C) for outlets of types F, E, K, L and J.
► Use the plug (type A (NEMA-1)) for outlets of type A (NEMA-1) and type B (NEMA-5).
► For other types of outlets, use an adapter from a specialist shop which is suitable for the connected loads of
the power supply (100–240 V/50–60 Hz).
► Connect the mains plug of the router to the power supply.
→ The WLAN is ready for the iPad, the base station and the sensors after a few minutes (approx. 10 min).
INFORMATION
The router has a touch screen. Various information on the router can be displayed by tapping the touch screen. It
cannot be used to modify settings.
12 743A250 Bionic Pro