Table of Contents
Advertisement
Use
19
7.12.3 Foot positioning belt
The power wheelchair can be equipped with one or two positioning belts for the feet. The positioning belt secures
the user's feet on the foot plate.
20
7.12.4 Chest and shoulder support
21
32
Swinging away the control panel holder
1) Apply some pressure to push the control panel
holder to the side.
→ The pivot element is released.
2) Swing the control panel holder away to the side.
INFORMATION: The pivot element locks in
place again when the holder is rotated back to
the original position.
Removing/installing the control panel
The control panel cannot be removed from the control
panel holder.
Using the foot strap
1) Open the hook-and-loop closure on the positioning
belt (see fig. 20, item 1).
2) Place the user's foot onto the foot plate with full
contact.
3) Pass the foot strap over the back of the user's foot
from above (not illustrated).
4) Fasten the strap above or beside the foot with hook-
and-loop (see fig. 20, item 1). Do not apply the foot
strap too tightly.
The power wheelchair can be equipped with a sternum
harness.
The sternum harness stabilises and positions the upper
body in relation to the back support. The midsection of
the pad supports the upper body and holds it in an
upright position (see fig. 21, item 1).
The following information helps with the adjustment and
use of the belt system.
Complete information about use, care and maintenance
is found in the instructions for use included with the belt
system.
490E163=*
Advertisement
Table of Contents
