Table of Contents
Advertisement
Use
WARNING
Inadequate transportation safety
Loss of safe restraint due to failure to observe transportation instructions
► Observe the following instructions for correct transport safety in the vehicle for transporting persons with
reduced mobility.
► If necessary, instruct the qualified personnel on the following information.
Securing the product in the vehicle for transporting persons with reduced mobility
The wheelchair is secured in the vehicle for transporting persons with reduced mobility with the help of four belt
loops, on which the vehicle side wheelchair restraint belts are attached.
The fixation points of the belt loops are marked with stickers. These stickers show where the user has to pass the
belt loops around the frame tube:
25
26
27
38
Finding fixation points
•
The stickers for labeling the front fixation points are
found on the front of the frame tube above the
caster attachment device on each side (see fig. 25,
item 1).
•
The stickers for labeling the rear fixation points are
found on the middle of the frame tube in line with
the front of the drive wheel on each side (see
fig. 25, item 2).
Securing the power wheelchair in the vehicle
1) Position the power wheelchair in the vehicle for
transporting persons with reduced mobility. For
more information, refer to section 5 in the brochure
"Transporting persons with reduced mobility", order
number 646D158=*.
2) Turn the control device off (see page 21).
3) Verify brake locking. Engage the brakes if needed
(see page 24).
4) Attach the vehicle side wheelchair restraint belts
(see next illustration).
Attaching belt loops and attachment straps
1) Front fixation points: Attach one belt loop around
each of the frame tubes on the left and right, wrap
ping them twice around the frame tubes at the
marked position (see fig. 27, item 1).
2) Engage the hook of the vehicle side wheelchair
restraint belt in both ends of the belt loop from the
outside on the left and right sides respectively (see
fig. 27, item 2).
3) Rear fixation points: Attach one belt loop around
each of the frame tubes on the left and right, wrap
ping them once around the frame tubes at the
marked position (see fig. 27, item 3).
490E163=*
Advertisement
Table of Contents
