Table of Contents
Advertisement
7.12.4.1 Adaptation
CAUTION
Improper adjustments
Injuries, malpositions, illness of the user due to adjustment changes
► The belt system is an important part of an individual seating unit/seating solution. Do not modify the installa
tion position and basic settings established by the qualified personnel.
► In case of problems with these adjustments (such as an unsatisfactory sitting position), promptly contact the
qualified personnel who fitted the product.
► Immediately consult the qualified personnel if you notice signs of discomfort or fear when using a belt sys
tem.
► Have the basic settings of the belt system checked regularly. Adjustments may be required due to the growth
of the user or because of changes in the course of the disease.
Small length adjustments of the belt by the user or an attendant (e.g. for clothing of different thickness) are pos
sible.
Positioning the user in the seat
•
Place the user in an upright, 90° seated position.
•
Ensure that the back is up against the back support pad.
•
The chest belt is intended to support the area over the sternum (breastbone) from the front. This is accom
plished when two fingers fit comfortably between the top of the belt and the armpit.
Possible positioning errors
•
The user's hips are not secured with a separate positioning belt (lap belt) (see page 28).
•
If the positioning system is too loose, the user can shift forward/slide down.
•
The positioning system collides with devices, accessories or supply hoses during installation and adjustment,
restricting their functionality.
•
The positioning system makes contact above the user's sternum (too high) or in the area of the soft part of the
stomach (too low).
Adjusting the belt length
Notes on correct adjustment are found in the instructions for use included with the belt system.
7.12.4.2 Use
WARNING
Incorrect application
Throttling, suffocation or strangulation due to sliding forward/down in the product
► The belt system must be used at all times while riding in the product. Always use the belt system in combina
tion with a correctly applied and adapted positioning lap belt to stabilise the pelvis.
► The belt system has to fit closely but not too tightly so the user is not injured. Sliding two fingers comfortably
between the positioning system and upper body should be possible.
► Ensure that the buckle lies in the middle of the body.
► Ensure that the belt system is not too close to the throat. Otherwise the upper straps have to be readjusted.
► Remove any objects or clothing which get caught.
CAUTION
Incorrect application
Risk of pressure points, constriction due to user error
► Applies only to upper body straps/vests, chest/shoulder straps: Follow the positioning instructions.
Ensure that the belt system lies against the chest evenly on both sides and is not too tight.
► Applies only to upper body straps/vests, chest/shoulder straps: Ensure that the belt system supports
the area of the upper body from the front. The belt system has to be applied/positioned so that the neck and
area of the throat remain free at all times.
490E163=*
Use
33
Advertisement
Table of Contents
