Table of Contents
Advertisement
13
7.5.2 Adjusting the seat upholstery
The seat upholstery usually does not need to be adjusted during the initial fitting. However, the tension can be
changed.
The seat upholstery is attached to the frame tubes with hook-and-loop straps.
1) If necessary: Place the seat cushion on the seat upholstery.
2) Open and loosen the rear hook-and-loop straps. Attach a hook-and loop strap from the middle diagonally over
the straps to secure them (see fig. 15).
3) Sit and position the user in the wheelchair.
4) Adjust the tension of the hook-and-loop straps to the weight and anatomical condition of the user, and fasten
them one after the other (see fig. 16).
INFORMATION: The two ends of the hook-and-loop strap have to overlap by at least 100 mm in each
case.
INFORMATION: Keep the respective front hook-and-loop straps tight.
INFORMATION: Deviating adjustments may be required in specific cases; this is the responsibility of
the attending therapist.
15
7.6 Adjusting the leg supports
The distance between the footplates and the sitting surface influences sitting stability. The height adjustment acts
on the pelvis and ischial bones.
7.6.1 Adjusting the height of the foot plate
The height of the foot plate can be subsequently adjusted by inserting spacers.
1) Loosen and remove the screw connection under the foot plate (see fig. 25).
2) Insert the four spacers according to the desired height.
3) Firmly retighten the screw connection.
Invader 480S26=20000_K
Settings and assembly instructions
14
16
17
Advertisement
Table of Contents
