Adjusting The Foot Plate - Otto Bock C1000 SF Instructions For Use Manual

Settings
4
5
6

6.7 Adjusting the foot plate

The height and angle of the footplate can be adapted to the requirements of the user.
The required footplate height depends on the lower leg length of the user.
The angle of the footplate in the sitting position affects the foot angle in the standing position.
Adjusting the height for the lower leg length
Two methods can be used to set the height.
12
Adjusting the position on the seat
There are receivers for a support on the right and left
side of the seat frame.
The receivers can be attached over the entire seat
depth range. Several slotted holes are provided in the
seat frame for adjustment purposes:
1) Loosen the two screws on the seat frame (see
fig. 4).
2) Slide the receivers forward or backward on the seat
frame along the slotted hole. If needed, select a dif­
ferent slotted hole for the receiver.
3) Retighten the two screws.
Adjusting the position on the back support
There are receivers for a support on the right and left
side of the back support.
Several slotted holes are provided in the back support
frame for adjustment purposes:
1) Loosen the two screws on the back support frame
(see fig. 5).
2) Slide the support receiver up or down along the
slotted hole in the back support frame. If needed,
select a different slotted hole for the receiver.
INFORMATION: It is also possible to mount the
support receiver at the same height as the
chest belt holder.
3) Retighten the two screws.
Adjusting the height
The height of the supports is dependent on how far they
can be inserted into the receiver:
1) Pull the support out of the receiver.
2) Loosen the two screws and move the connection
piece up or down (see fig. 6).
3) Retighten the two screws. The support must be fully
guided into the receiver.
Adjusting the width
The width of the supports can be adjusted by ±40 mm
per side after loosening the connecting piece:
1) Pull the support out of the receiver.
2) Loosen the two screws on the connecting piece
(see previous section).
3) Turn the supports to the inside or outside.
4) Retighten the two screws. The support must be fully
guided into the receiver.
C1000 SF