Side Panels; Removing/Installing The Side Panels; Legrests; Removing/Installing The Leg Supports - Otto Bock Skippi Instructions For Use Manual

They are located on the underside of the battery packs (see fig. 6).
6

7.3 Side panels

The side panels protect the user and his/her clothing from getting dirty.
The installed armrests offer the user additional support for the forearms.

7.3.1 Removing/installing the side panels

To make getting in from the side easier or for transportation, the side panels can be removed if needed.
7

7.4 Legrests

The legrests support the user's feet.
The height of the legrests has been adjusted by qualified personnel to the length of the user's lower leg.
The angle of the footrest has been set by the qualified personnel so that it allows the ankles to rest in a comfortable
position.

7.4.1 Removing/installing the leg supports

CAUTION
Incorrect handling when getting in
Crushing, pinching, impacts due to incorrect handling
► Do not reach into the danger area with your fingers when folding the legrest or footplates up or down.
► Never step on the footplates when getting in and out.
► Note projecting edges.
INFORMATION
For detaching/attaching the mechanically elevating leg supports: see page 37.
Skippi
Installing the fuse
1) Remove the battery packs (see page 14).
2) Remove the fuse from the supplied protective cover.
3) Insert the fuse into the slot provided (see fig. 6).
4) Reinstall the battery packs (see page 14).
Removing the fuse
Prerequisite: The control device is switched off.
>
1) Remove the battery packs (see page 14).
2) Take the fuse out of the slot (see fig. 6).
3) Reinstall the battery packs (see page 14).
Removing the side panel
1) Loosen the wing screw on the side panel holder
(see fig. 7).
2) Pull the side panel out from the side panel holder
and set it aside.
3) Only for side panel with control panel:
→ Carefully let the side panel with the control pan­
el hang down while getting in.
→ For transporting the power wheelchair, place
the side panel on the seat.
Installing the side panel
1) Insert the side panel into the side panel holder.
2) Re-tighten the wing screw on the side panel holder
(see fig. 7).
Use
15