Removing/Installing The Leg Supports - Otto Bock Dino 3 Instructions For Use Manual

Use
29
The product can be equipped with one of the following leg supports:
• Single-panel, with calf strap, aluminium (see fig. 30)
• Single-panel for short lower leg length, with calf strap, aluminium (see fig. 31)
• With single-panel foot plate for seating shell interface, steel (see fig. 32)
• Segmented, with calf strap, aluminium (see fig. 33)
• Segmented, elevating with ratchet joint, with calf strap, aluminium (see fig. 34)
30
33

7.6.1 Removing/installing the leg supports

a) Removing/installing the following leg support:
• Segmented, elevating with ratchet joint (aluminium)
Removing the leg support
1) If necessary: Open the calf strap and disengage it from the holder (see fig. 35, item 1).
2) Fold up the foot plates (see Page 29).
3) Release the leg support locking mechanism (see fig. 36, item 1).
4) Swing the leg support out by 90° (see fig. 36).
5) Pull the leg support up and remove it.
Installing the leg support
1) Slide the leg support into the holder on the front frame tube from above. The leg support has to face out by 90°.
2) Swing the leg support in until the locking mechanism engages (see fig. 36).
3) Fold down the foot plates.
4) Optional: Engage the calf strap on the holder (see fig. 35, item 1) and adjust the length of the calf band. To do
so, open the hook-and-loop closure, make the adjustment and fasten the closure.
28
31
34
32
Dino 3