Only included with 757B35=0 MyoEnergy Integral:
Protection against penetration of solid foreign objects with a diameter > 2.5 mm,
protection against water spray
11.2 Operating states/error signals
11.2.1 Status signals
Charging receptacle
LED shows green light
LED shows yellow light
LED shows orange light
11.2.2 Beep signals
The following beep signals are set by default:
Beep signal
1 x long
2 x short
3 x short
The following beep signals exist only in conjunction with the 7in1 Controller (9E420=*):
Beep signal
1 x long
2 x short
2 x short
Continuous pulses (as long
as
the button is being
pressed)
1 Avant-propos
INFORMATION
Date de la dernière mise à jour : 2020-12-22
Veuillez lire attentivement l'intégralité de ce document avant d'utiliser le produit ainsi que
►
respecter les consignes de sécurité.
Apprenez à l'utilisateur comment utiliser son produit en toute sécurité.
►
Adressez-vous au fabricant si vous avez des questions concernant le produit ou en cas de
►
problèmes.
22
Additional display
-
LED on charging
receptacle lights up
briefly
-
Status
Disconnect the MyoLino Link:
Prosthesis was previously switched off
Connect the MyoLino Link
Disconnect the MyoLino Link:
Prosthesis was previously switched on
Parental access switch
Event
Battery fully charged
Battery 50% charged
Battery empty
Event
•
Turn off prosthesis on charging receptacle
•
Charging begins (charging plug connected
to charging receptacle)
•
Charging ends (charging plug disconnected
from charging receptacle)
Switch on prosthesis
Battery voltage too low, prosthesis shuts off auto
matically
Français