Data Transfer Between The Product And The Pc; Preparing The Product To Connect To The Adjustment Software; Shortening The Tube Adapter - Otto Bock Kenevo 3C60 Instructions For Use Manual

Preparing the product for use
data for them can be saved and printed for documentation. These data can be retrieved if required and imported
into the product.
Please consult the integrated online help in the adjustment software for further information.
INFORMATION
The 4X445 K-Soft adjustment software, version 1.6 or higher, is required for correct alignment. If K-Soft is
on hand in version 1.0 or higher, it can be updated.
Note the system requirements!
Updating the K-Soft adjustment software
1) Click "Help > About" in the menu bar of the Data Station when you are connected to the Internet.
→ The window opens with the versions of the previously installed programs and the manufacturer's address.
2) Click the "Check for updates" button in this window.
→ A search for updates of previously installed software products and components is performed via the Inter­
net.
3) If updates are available, click "Download" in the column on the right in order to download and save the
update.
4) Extract the "ZIP file" and execute it.
INFORMATION
Cybersecurity
► Keep your operating system up to date and always install any available security updates.
► Protect your computer from unauthorised access (e.g., by using virus scans, password protection etc.).
► Do not use unsecured networks.
► Please contact the manufacturer if you suspect cybersecurity problems.

6.1.1.2 Data transfer between the product and the PC

Product settings using the adjustment software can only be made via Bluetooth data transfer. For this purpose, a
Bluetooth wireless connection must be established between the product and the PC using the "60X5 BionicLink
PC" Bluetooth adapter. The installation and use of the "60X5 BionicLink PC" adapter are described in the instruc­
tions for use supplied with the adapter.

6.1.1.3 Preparing the product to connect to the adjustment software

If the product does not emit any signals when querying the charge level (see page 71), the battery is drained or the
product is switched off.
Switching on the product
1) Connect the power supply with battery charger to the wall socket.
2) Connect the battery charger to the product.
3) Wait for feedback signals.
4) Disconnect the battery charger from the product.
→ After feedback signals are emitted (self test), the product is switched on.
Switching on Bluetooth
Upon delivery, the Bluetooth function of the prosthesis is switched off.
When the Bluetooth function is switched off, it is only turned on for 2 minutes after connecting/disconnecting the
battery charger and is then turned off again automatically. When a connection with the PC is active (the
symbol is lit up), the Bluetooth function is not switched off automatically.

6.1.2 Shortening the Tube Adapter

CAUTION
Incorrect processing of tube
Falling due to damage to the tube.
► Do not clamp the tube into a vice.
► For shortening the tube, use only a tube cutter.
72 Kenevo 3C60/3C60=ST