Turning Bluetooth On The Prosthesis On/Off; Querying The Prosthesis Status; Switching Off The Product - Otto Bock Kenevo 3C60 Instructions For Use Manual

Parameter
Donning function
¹ To use these functions in the Cockpit app, they need to be enabled or turned on in the adjustment app.

8.7 Turning Bluetooth on the prosthesis on/off

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function only available in
basic mode) or by connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. During this time, the app must be started and used to establish a connection. If required, Bluetooth on
the prosthesis can be switched on permanently afterwards (see page 91).
Switching off Bluetooth
1) With the component connected, tap the
→ The navigation menu opens.
2) Tap the "Functions" option in the navigation menu.
3) Tap the "Deactivate Bluetooth" option.
4) Follow the on-screen instructions.
Switching on Bluetooth
1) Turn the component over or connect/disconnect the battery charger.
→ Bluetooth is switched on for approx. 2 minutes. The Cockpit app must be started within this time to estab­
lish a connection to the component.
2) Follow the on-screen instructions.
→ If Bluetooth is switched on, the

8.8 Querying the prosthesis status

1) With the component connected, tap the
2) Tap the "Status" option in the navigation menu.
Menu option
Trip: 1747
Step: 1747
Batt.: 68

8.9 Switching off the product

CAUTION
Using the product while switched off
Falling due to unexpected behaviour of the product because of changed damping behaviour.
► Before using the product, switch it on by connecting the power supply and battery charger.
In certain cases, e.g. for storage or transportation, the prosthesis can be purposely switched off. It can only be
switched on by connecting to a live outlet, a power supply and a battery charger.
Switching off
The product can be switched off by briefly connecting/disconnecting the battery charger 3 times.
1) Connect the battery charger to the product and wait for the beep signal.
Kenevo 3C60/3C60=ST
Adjustment soft­ Cockpit app
ware range adjustment
range
0/Off – deactiv­ 0/Off – deactiv­
ated ated
1/On – activated 1/On – activated
icon in the main menu of the Cockpit app.
icon appears on the screen.
icon in the main menu of the Cockpit app.
Description
Daily step counter
Total step counter
Current prosthesis charge level, as a
percentage
Meaning
If the knee joint is not loaded for a few
seconds after disconnecting the charger, the
prosthesis can be flexed. Flexion makes put­
ting on the prosthesis easier. Ending knee
flexion or loading the prosthesis immediately
reactivates the configured operating state.
This function can be activated in mode A, B
or B+.
Possible actions
Reset the counter by tapping the
"Reset" button.
Information only
Information only
Use
91