Display Of The Current Charge Level; Display Of Battery Charge Level Without Additional Devices; Display Of The Current Charge Level Using The Cockpit App; Preparing The Product For Use - Otto Bock Kenevo 3C60 Instructions For Use Manual

Battery
charger
Battery is fully charged, or the temperature has exceeded/fallen below the permissible range for the
knee joint during charging. Check current charge level (see page 71).

6.2 Display of the current charge level

6.2.1 Display of battery charge level without additional devices

INFORMATION
The charge level cannot be displayed during the charging process, e.g. by turning the prosthesis over. The
product is in charging mode.
Beep signal
5x short
4x short
3x short
2x short
1x short
1x short

6.2.2 Display of the current charge level using the Cockpit app

Once the Cockpit app has been started, the current charge level is displayed in the bottom line of the screen:

6 Preparing the product for use

6.1 Alignment

The following alignment guidelines contain descriptions for connecting the knee joint to a prosthetic socket. In
principle, the alignment of the prosthesis is independent of the type of connection for the knee joint. In case of a
connection to an osseointegrated, percutaneous implant system, a socket is not used during bench alignment in
the alignment apparatus. In this case, the central proximal point on the prosthetic socket corresponds to the
trochanter of the thigh bone (see illustration in the section "Bench alignment in the alignment apparatus" see
page 73).
Ensure that possible flexion or adduction of the transfemoral residual limb can be compensated to a permissible
extent by an adapter approved by the implant manufacturer in the course of static alignment optimisation. Safe
functioning of the knee joint is only guaranteed with biomechanically correct alignment.

6.1.1 Settings with the "K-Soft" adjustment software

6.1.1.1 Introduction

The "K-Soft" adjustment software makes it possible to optimise the product settings for a patient. The adjustment
software provides step-by-step guidance through the adjustment process. After the settings are configured, the
Kenevo 3C60/3C60=ST
1) Turn the prosthesis 180° (the sole of the foot has to face up).
2) Hold still for 2 seconds and wait for beeps.
Vibration signal
3x long
5x long
1. 38% – Charge level of battery for currently connected component
Preparing the product for use
Battery charge level
more than 80%
65% to 80%
50% to 65%
35% to 50%
20% to 35%
less than 20%
71