Scope Of Delivery And Accessories; Scope Of Delivery; Accessories - Otto Bock Kenevo 3C60 Instructions For Use Manual

NOTICE
Failure to observe the system requirements for the installation of the Cockpit app
Mobile device malfunction.
► The Cockpit App should only be installed on mobile devices and versions which comply with the specifica­
tions in the respective online stores (e.g. Apple App Store, Google Play Store, ...)
INFORMATION
The illustrations in these instructions for use are only examples and may deviate from the respective mobile device
being used and the version.

5 Scope of Delivery and Accessories

5.1 Scope of delivery

• 1 pc. Kenevo 3C60=ST (with threaded connector)
or
• 1 pc. Kenevo 3C60 (with pyramid connector)
• 1 pc. AXON 2R17 tube adapter or
• 1 pc. 2R20 AXON tube adapter or
1 pc. 2R21 AXON tube adapter with torsion
• 1 pc. 757L16-4 power supply
• 1 pc. 4E70-1 inductive charger
Cockpit app for download from the website: https://www.ottobock.com/cockpitapp
The Cockpit app has to be installed in version 2.5.0 or higher for use with this knee joint.
• "4X441-V2=IOS Cockpit" iOS app
• "4X441-V2=ANDR Cockpit" Android app

5.2 Accessories

The following components are not included in the scope of delivery and may be ordered separately:
• Kenevo Protective Cover 4X840
• "4X445=V1.6 K-Soft" or higher adjustment soft­
ware, update by Internet download.
Note the system requirements!
Charging the prosthesis battery
The following points must be observed when charging the battery:
• Use the 757L16-4 power supply and 4E70-1 battery charger to charge the battery.
• The full surface of the inductive charger must be in contact with the receiver of the charging unit. This must be
verified, particularly when fabricating a cosmetic foam cover. Prior to application, check the contact surfaces
for dirt and ensure that no objects are adhering to them.
• The capacity of a fully charged battery is sufficient for one full day.
• We recommend charging the product once a day when used by the patient on a daily basis.
• For the maximum operating time with one battery charge, disconnecting the battery charger from the product
only immediately before using the product is recommended.
• The battery should be charged for at least 3 hours prior to initial use.
• Note the permissible temperature range for charging the battery (see page 95).
• The battery may discharge while the product is not being used.
• The tube adapter must be connected before disconnecting the battery charger, otherwise an error message
will result (see page 99).
Kenevo 3C60/3C60=ST
Scope of Delivery and Accessories
• 1 pc. Instructions for use (qualified personnel)
• 1 pc. Instructions for use (user)
• 1 pc. prosthesis passport
• 2 pc. 4H107 8° flexion stop (already installed on
delivery)
• 2 pc. 4H108 16° flexion stop
• 1 pc. cosmetic case for battery charger and power
supply
• 3S26 cosmetic foam cover
• 4X633 Kenevo foam cover toolset
• 4X634 Kenevo foam cover charging set
69