Related Manuals for Otto Bock 3291
Summary of Contents for Otto Bock 3291
- Page 1 Multi-Positioning System (MPS) Seat Instructions for Use ©2008 Otto Bock HealthCare LP • 07101371.1 1/08...
-
Page 3: Table Of Contents
Table of Contents 1 General Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 1.1 Preface . -
Page 4: General Information
Danger! 1.5 Service and Repairs Never leave the child unattended in the MPS Seat. Service and repairs on the MPS Seat may only be carried out by Otto Bock HealthCare suppliers. Should any problems arise, please contact the supplier Danger! of your MPS Seat. -
Page 5: Mps Seat Overview
Your MPS Seat is designed to grow with your child. But it is important to 4.1 Attaching the MPS Seat work with your dealer to properly adjust the MPS Seat. Only Otto Bock parts Depending on the mobility base with which it is being used, the MPS seat and accessories that are made specifically for the MPS Seat should be used. -
Page 6: Maintenance And Care
5 Maintenance and Care 6.2 Backrest Height 5.1 Introduction 1. Detach upholstery from backrest. Proper maintenance will improve performance and extend the useful life of 2. Loosen screws inside the six knobs located on rear of backrest The MPS Seat. (Fig. -
Page 7: Seat Width
6.5 Armrest Height and Angle 7. After adjusting the seat depth, it may be necessary to adjust the position of the Ischial shelf. 1. Loosen both knobs located under armrest (Fig. 7, Pos. A). a. To do so, peel back the 1⁄4˝ (.6 cm) layer of top foam far enough to expose the Ischial shelf completely (Fig. -
Page 8: Butterfly Harness
6.8 Butterfly Harness 6.10 Headrest Height 1. Pull nylon shoulder straps in the rear of the back to desired length 1. Height: Loosen star knob on backrest panel (Fig. 11, Pos. A). Set (Fig. 10, Pos. A) and/or pull nylon straps on bottom of harness to desired headrest to desired height and tighten star knob. -
Page 9: Knee Angle
6.12 Knee Angle 7.2 Shoe Holders 1. Loosen knob located at the top of the footrest (Fig. 14, Pos. A). 1. Drill holes (#7 or .20˝ or 3/64˝ (1.1 mm)) in the footplate in the desired location. 2. Elevate footrest to desired location and tighten knob. Note: The telescoping leg rest allows for adjustments in knee angle without having 2. -
Page 10: Foot Straps W/ Hook And Loop Closures
7.4 Foot Straps w/ Hook and Loop Closures 7.8 Curved Swing Away Lateral 1. Drill holes (drill size H or. 266˝ or 17/64˝ (6.7 mm)) in the footplate in the 1. Attach lateral using provided hardware as shown below (Fig. 22). desired location (Fig. -
Page 11: Technical Data
(1) year from the date of purchase by the consumer. Otto Bock’s sole obligation under this limited warranty shall be to repair or replace products covered... - Page 12 Manufactured by: Otto Bock HealthCare North America Two Carlson Parkway North, Suite 100 Minneapolis, MN 7 USA Phone 800.328.08 • Fax 800.2.2...