INFORMATION
After activating the "visibility" of the component (holding the component with the sole of the foot facing up, or con
necting and then disconnecting the battery charger), the component can be recognised by another device
(e.g. smartphone) within 2 minutes. If registration or establishing the connection takes too long, the process of
establishing a connection is cancelled. In this case, hold the component with the sole of the foot facing up again,
or connect and then disconnect the battery charger.
7.3.2 Deleting a component
1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the entry "Manage components".
3) Tap the "Edit" button.
4) Tap the
symbol under the component you want to delete.
→ The component is deleted.
7.3.3 Connecting component with multiple mobile devices
The connection for a component can be stored on more than one mobile device. However, only one mobile device
can be connected to the component at one time.
If there is an existing connection between the component and a different mobile device, the following information
appears while the connection is being established with the current mobile device:
Connect to this component?
Component was connected to
another device.
Establish connection?
Cancel
8 Use
8.1 Movement pattern in activity mode A (locked mode)
8.1.1 Standing
The knee joint is locked in the flexion direction. Therefore, proceed as you would with a rigid
knee joint.
INFORMATION: In response to a sitting movement, the joint switches to high flexion
resistance.
8.1.2 Walking
Initial attempts at walking with the prosthesis always require the instruction of trained, quali
fied personnel.
The knee joint is locked in the flexion direction. Therefore, proceed as you would with a rigid
knee joint.
Kenevo 3C60/3C60=ST
► Tap the "OK" button.
→ The connection to the last connected mobile device is broken off and
established with the current mobile device.
OK
Use
81