Completing The Alignment; Cockpit App - Otto Bock Kenevo 3C60 Instructions For Use Manual

9) Take the centring plate off the knee joint.
Installing the charging shaft
7
The required tools and components are included in the 4C634 Kenevo foam cover charging set: char­
>
ging shaft receiver, charging shaft, cover for charging shaft, 65X3 O-ring
1) Attach the charging shaft receiver to the knee joint using the O-ring. (see fig. 7)
2) Shorten the charging shaft using a suitable tool (see fig. 8) so the length corresponds to the thickness of the
foam cover material.
3) Deburr the cut edge.
4) Clip the charging shaft cover to the charging shaft.
5) Pull on the foam cover.
6) Insert the charging shaft and push it in until it engages in the charging shaft receiver. (see fig. 9)

6.3 Completing the alignment

Upon finalising all settings, all screw connections must be tightened to the proper tightening torque (see page 95).
INFORMATION
A calibration procedure must be performed after each change to the tube adapter, prosthetic foot or knee joint
using the adjustment software.
CAUTION
Incorrectly secured screws
Falling due to breakage of load-bearing components caused by screw connections coming loose.
► After completing all settings, the set screws in the tube adapter must be secured before they are tightened to
the specified torque.
► The screws in the clamp bracket must not be secured but only tightened to the specified torque.

7 Cockpit app

The patient can change the behaviour of the product to a certain extent with the Cockpit
app. In addition, information about the product (step counter, charge level, etc.) can be
retrieved. The adjustment software can be used to trace the change at the patient's next
appointment.
Kenevo 3C60/3C60=ST
8
Cockpit app
9
77