Walking Backwards; Using A Bicycle Ergometer - Otto Bock Kenevo 3C60 Instructions For Use Manual

Use

8.3.9 Walking backwards

While walking backwards, the hydraulics keep the knee joint stable with high flexion resist­
ance.

8.4 Using a bicycle ergometer

The "Bicycle ergometer" MyMode allows a bicycle ergometer to be used without exiting the
currently selected activity mode.
Note the prerequisites for switching and the differences for activation in the respective activ­
ity modes.
Prerequisites for activating the "Bicycle ergometer" MyMode
• A bicycle ergometer is required. Switching is not possible for recumbent bicycles or so-called pedal trainers.
• The bicycle ergometer must have a freewheel.
• The user must be in the sitting position.
• The sitting position must not be too high, otherwise the knee is extended during the pedaling movement, end­
ing the MyMode.
• The sitting position must not be too low. Note the permissible flexion range of the knee joint.
• The feet have to be positioned on the pedals.
• Pedaling movements must be possible.
Activating the "Bicycle ergometer" MyMode (activity mode A, B, B+)
1) Sit on the bicycle ergometer with the leg extended.
2) Hold the leg horizontally until the knee joint flexes on its own due to gravity.
3) Put the feet on the pedals and perform pedaling movements within one minute, or activate the "2.Bicycle
ergometer" MyMode using the Cockpit app.
→ After a few pedaling movements, these are recognised by the knee joint and a short beep and vibration sig­
nal is produced. If this signal is not produced, the time limit for positioning the feet on the pedals (one
minute) was exceeded or the prerequisites for activating this MyMode are not met.
→ The short beep and vibration signal is produced periodically at intervals during the pedaling movement until
the resistances in the flexion and extension direction have been reduced to the extent that the knee joint
moves freely.
→ This MyMode (2. Bicycle ergometer)is shown in the overview in the Cockpit app.
Activating the "Bicycle ergometer" MyMode (activity mode C)
1) Sit on the bicycle ergometer.
2) Put the feet on the pedals.
3) Perform pedaling movements or activate the "2.Bicycle ergometer" MyMode using the Cockpit app.
→ After a few pedaling movements, these are recognised by the knee joint and a short beep and vibration sig­
nal is produced. If this signal is not produced, the prerequisites for activating this MyMode were not met.
→ The short beep and vibration signal is produced periodically at intervals during the pedaling movement until
the resistances in the flexion and extension direction have been reduced to the extent that the knee joint
moves freely.
→ This MyMode (2. Bicycle ergometer) is shown in the overview in the Cockpit app.
88 Kenevo 3C60/3C60=ST