Using A Wheelchair; Changing Prosthesis Settings - Otto Bock Kenevo 3C60 Instructions For Use Manual

Deactivating the "Bicycle ergometer" MyMode (activity mode A, B, B+, C)
► From the sitting position, either extend the knee or take the foot off the pedal and put it on the floor. The foot
has to be ahead of the knee joint when it is set on the floor.
→ This is recognised by the knee joint and a long beep and vibration signal is produced. If this signal is not
produced, either repeat the process or switch to the "1. Basic Mode" MyMode using the Cockpit app.
→ This MyMode is shown in the overview in the Cockpit app.

8.5 Using a wheelchair

When sitting in a wheelchair, the joint can be locked in the flexed position for short distances. The lock can be
engaged in any position from an angle of 45°. This prevents the foot from dragging on the floor. To use this func­
tion, it must be enabled in the adjustment software.
Locking the joint
► Raise the foot and hold it still in the desired position.
Disengaging the lock
The lock can be disengaged in the following ways:
•
•
•
INFORMATION
Turning the "Wheelchair function" function off/on using the Cockpit app
If the "Locking function for wheelchair" function was turned on in the adjustment software, the "Wheelchair
function" function can be turned off and back on again using the Cockpit app.

8.6 Changing prosthesis settings

Once an active connection to a component has been established, the settings of the respective active mode can
be changed using the Cockpit app.
INFORMATION
Bluetooth on the prosthesis has to be switched on to change the prosthesis settings (see page 91).
Information for changing the prosthesis settings
• Before changing settings, always check the main menu of the Cockpit app to make sure the correct component
has been selected. Otherwise parameters could be changed for the wrong component.
• It is not possible to change prosthesis settings nor to switch to a different mode while the prosthesis battery is
being charged. Only the status of the prosthesis can be called up. Instead of the
appears in the bottom row of the screen in the cockpit app.
• The O&P professional's setting is in the middle of the scale. After making adjustments, this setting can be
restored by tapping the "Standard" button in the Cockpit app.
• Prosthesis settings should be optimised using the adjustment software. The Cockpit app is not intended for
use by the O&P professional to set up the prosthesis. The patient can use the app to change the behaviour of
the prosthesis to a certain extent during everyday use (e.g. while becoming accustomed to the prosthesis). The
O&P professional can use the adjustment software to track these changes at the patient's next appointment.
Kenevo 3C60/3C60=ST
The lock engages automatically.
INFORMATION: At full extension, the lock engages in a slightly flexed position so
the foot can be lifted in order to release the lock.
Extended pressure on the ball of the foot.
Extended pressure on the toes (from the top of the foot).
Lift the foot (extend the knee) and allow the foot to lower again.
Use
symbol, the symbol
89