Cockpit App Navigation Menu; Managing Components; Adding Component - Otto Bock Kenevo 3C60 Instructions For Use Manual

Cockpit app

7.2.1 Cockpit app navigation menu

7.3 Managing components

Connections with up to four different components can be stored in the app. However, a component can only be
connected to one mobile device at a time.
INFORMATION
Before establishing the connection, observe the points in the section "Initial connection between Cockpit app and
component" (see page 78).

7.3.1 Adding component

1) Tap the symbol in the main menu.
→ The navigation menu opens.
2) In the navigation menu, tap the "Manage components" item.
3) Hold the prosthesis with the sole of the foot facing up, or connect and then disconnect the battery charger, in
order to activate recognition (visibility) of the Bluetooth connection for 2 minutes.
4) Tap the "+" button.
→ The Connection Wizard opens and guides you through the process of establishing a connection.
5) Follow the subsequent instructions on the screen.
6) After the Bluetooth PIN is entered, a connection to the component is established.
→ While the connection is being established, three beep signals sound and the
The symbol is displayed when the connection has been established.
→ Once the connection has been established, the data are read from the component. This process may take
up to a minute.
The main menu will then appear with the name of the connected component.
INFORMATION
If establishing a connection to a component is not possible, perform the following steps:
► Delete the component from the Cockpit app if applicable (see the section "Deleting a component")
► Add the component again in the Cockpit app (see the section "Adding a component")
80
Tap the symbol in the menus to display the navigation menu. Additional
settings for the connected component can be configured in this menu.
Product
Name of the connected component
MyModes
Return to the main menu to switch MyModes
Functions
Call up additional functions of the component (e.g. turn off Bluetooth) (see
page 91)
Settings
Change settings of the currently selected mode (see page 89)
Status
Query status of the connected component (Querying the prosthesis status)
Manage components
Add or delete components (see page 80)
Imprint/Info
Display information/legal notices for the cockpit app
symbol appears.
Kenevo 3C60/3C60=ST