Using The Product In The Vehicle; Restrictions For Use - Otto Bock Start M1 Instructions For Use Manual

Use
→ The belt loops are installed.
38

6.17.3 Using the product in the vehicle

The product has been tested according to ISO 7176-19.
Securing the product in the vehicle for transporting persons with reduced mobility
1) Position the product in the vehicle for transporting persons with reduced mobility. For further information see
section 5 in the brochure "Using your product for transportation in a wheelchair accessible vehicle", order
number 646D158.
2) Engage the attachment straps in the belt loops at the front and rear, and then tighten them.
→ The product showing the correct positioning of the attachment straps (see fig. 40).
Placement of the restraint lap belt
1) Recommendation: Fold the side panels back (see fig. 41, item 1).
2) Pull each end of the restraint lap belt from the inner side of the seat through to the outside (see fig. 41, item 2).
3) Engage the end of the restraint lap belt on the pin (see fig. 41, item 3).
4) Fold the side panels forward again.
→ The restraint lap belt is pulled through and fastened.
→ The belt runs respectively between the side panel and seat cushion.
40

6.17.4 Restrictions for use

WARNING
Risk of accidents and injury due to using the product with certain settings and/or installed options
Severe injury in case of accidents due to options coming loose
► Before using the product as a seat in a vehicle for transporting persons with reduced mobility, remove options
that need to be taken off for safe transportation. Please observe the following table.
► Stow all dismantled components securely in the vehicle for transporting persons with reduced mobility.
► Please note that certain settings on the product exclude the use of the product in a vehicle for transporting
persons with reduced mobility.
26 | Ottobock
39
41
Start M1