Changing Control Unit Parameters; Final Inspection - Otto Bock B500 Series Instructions For Use Manual

Handover

6.3 Changing control unit parameters

WARNING
Incorrect configuration settings
Falling, tipping over, collision due to programming errors
► Programming may only be performed by qualified per­
sonnel trained by the manufacturer. The manufacturer of
the product and the control unit manufacturer are not
liable in case of damage caused by programming which
was not performed properly and/or which was not
adjusted properly according to the user's abilities.
► Note that modified parameter settings in the configura­
tion can lead to changes in driving characteristics. In
particular, changes to the speed, acceleration, braking
or joystick settings can lead to unexpected and there­
fore uncontrollable driving characteristics and cause an
accident.
► After configuration/programming is complete, the user
must test the driving characteristics of the product
under the supervision of the qualified personnel.
6.3.1 Wheelchair control options
If necessary, the pre-programmed wheelchair control sys­
tem can be adjusted to the specific user requirements.
Further information on programming can be found in the
service manual (647G744=DE/647G744=EN)
16 | Ottobock
Information on operation and troubleshooting of the wheel­
chair control unit can be found in the instructions for use
(user).
6.3.2 Attendant control
The power wheelchair can be ordered and equipped with an
attendant control. It may be necessary to fit the already
installed attendant control to the actual body size of the
attendant.
The instructions for use (user) contain information on oper­
ating the attendant control.
6.3.3 Push-button module
The 500 advanced model can be ordered and equipped with
a push-button module.
The installation position of the push-button module may have
to be adjusted so that the user can reach it easily.
The instructions for use (user) contain information on oper­
ating the push-button module.
7 Handover

7.1 Final inspection

A final inspection should be performed before delivery of the
power wheelchair:
• Are all options installed according to the order form?
• Was the power wheelchair fitted optimally to the physical
and mental condition of the user (seat, armrests,
footrests, control panel, additional controls)?
B500 Family