Changing Control Unit Parameters - Otto Bock C1000 SF Instructions For Use Manual

Settings
Fig. 14 Adjusting the seat cushion length

6.12 Changing control unit parameters

WARNING
Incorrect configuration settings
Falling, tipping over, collision due to programming errors
► Programming may only be performed by qualified per­
sonnel trained by the manufacturer. The manufacturer
of the product and the control unit manufacturer are
not liable in case of damage caused by programming
which was not performed properly and/or which was
not adjusted properly according to the user's abilities.
24 | Ottobock
► Note that modified parameter settings in the configura­
tion can lead to changes in driving characteristics. In
particular, changes to the speed, acceleration, braking
or joystick settings can lead to unexpected and there­
fore uncontrollable driving characteristics and cause
an accident.
► After configuration/programming is complete, the user
must test the driving characteristics of the product
under the supervision of the qualified personnel.
6.12.1 Wheelchair control options
If necessary, the pre-programmed wheelchair control sys­
tem can be adjusted to the specific user requirements.
Information on operation and troubleshooting of the wheel­
chair control unit can be found in the instructions for use
(user).
Further information on programming can be found in the
service manual.
6.12.2 Attendant control
The power wheelchair can be ordered and equipped with an
attendant control. It may be necessary to fit the already
installed attendant control to the actual body size of the
attendant.
The instructions for use (user) contain information on oper­
ating and troubleshooting the attendant control.
C1000 SF