(clutch housing side).
24. Measure the height (B) from contacting surface of front case retainer.
25. Measure height(C) of retainer bearing from contacting surface of snap ring.
Measured value: A-B-C
End play: 0 ~ 0.1 mm (0-0.0039 in)
Select a shim that is equal to the measured value considering the end play.
26. Install outer race and spacer on the counter shaft taper bearing.
27. Install the transmission case housing onto the sealing surface of the adapter.
Tightening torque:
43-55 N·m (430-550 kg·cm, 31-40 lb·ft)