5. Install return spring over rail shaft in transfer case to rest on shift fork.
6. Install magnet in slot in transfer case.
7. Apply continuous 1/16 in. (1.6 mm) bead of sealant (Neutral Cure RTV, Loctite 598) all around transfer
case mounting face for cover assembly. Center sealant bead between edges of face. Circle bolt holes.
Remove excess if sealant bead is larger than 1/16 in. (1.6 mm).
8. Install cover assembly on transfer case. All of the following alignment conditions must be met for the
cover assembly to seat on transfer case properly.
(1) Cover holes with transfer case dowel pins.