Advertisement
24. Install tone wheel onto the front output shaft. Make sure the spline on the tone wheel engages the
spline on the front output shaft.
25. Install clutch pack assembly onto the rear output shaft.
Make sure that the spline on the clutch pack engages to the spline of the sprocket.
26. Install snap ring onto the rear output shaft. Start the snap ring over the spline and use the wave spring
to seat the snap ring in the snap ring groove.
If the snap ring will not install, the thrust washer inside the clutch pack may not be seated properly.
27. Three slots on the thrust washer must be aligned with the three tabs on the clutch pack housing.
28. Install the apply cam onto the rear output shaft.
29. Install three balls into the apply cam.
30. Install cam and coil housing assembly onto rear output shaft.
31. Install thrust bearing assembly onto output shaft.
Advertisement
